Mustang V6-4.0L (2008)
Removal
Both sides
1. Remove the camshaft roller followers.
2. NOTE: The RH and LH camshaft timing procedure must be carried out when either camshaft is serviced.
Rotate the crankshaft clockwise to position the No. 1 cylinder at top dead center (TDC).
3. CAUTION: Do not rotate the engine counterclockwise. Rotating the engine counterclockwise will result in incorrect timing of the engine.
NOTE: The special tool must be installed on the damper and should contact the engine block. This positions the piston at TDC.
Install the special tool.
RH side
4. Install the special tools on the rear of the RH cylinder head and tighten the top 2 clamp bolts to 10 Nm (89 lb-in).
5. NOTE: The RH camshaft sprocket is a LH-threaded bolt.
Using the special tool and the Camshaft Sprocket Nut Socket, loosen the camshaft sprocket bolt.
