Mustang V6-4.0L (2008)
Exhaust Manifold: Service and Repair
Exhaust Manifold - LH
Exhaust Manifold - LH
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the 2 catalytic converter-to-exhaust manifold nuts.
^
Discard the nuts.
3. Disconnect the EGR system module tube from the exhaust manifold.
4. Remove the 6 nuts, the LH exhaust manifold and the gasket.
^
Discard the nuts and gasket.
5. Clean and inspect the LH exhaust manifold.
6. Remove and discard the 6 LH exhaust manifold studs.
Installation
1. Install the 6 new LH exhaust manifold studs.
^
Tighten to 12 Nm (9 lb-ft).
2. Install the new LH exhaust manifold gasket, manifold and 6 new nuts.
^
Tighten to 23 Nm (17 lb-ft).
3. Connect the EGR system module tube to the exhaust manifold.