Mustang V6-4.0L (2008)
Installation
1. Install the intermediate pipe.
2. NOTE: Install a new exhaust clamp.
Connect the intermediate pipe into the muffler.
3. Tighten the exhaust clamp.
^
The exhaust clamp should be installed so that it is up to, but not over, the bottom of the notches.
^
Tighten to 48 Nm (35 lb-ft).
4. Place the new exhaust coupler over the intermediate pipe. Position the intermediate pipe to the catalytic converter, slide the coupler into position
until the converter button is seated into the intermediate pipe notch.
5. Push the muffler forward to fully seat the pipe in the coupler.
^
Verify that the intermediate pipe is inserted into the coupler correctly. Correct installation is achieved when the coupler terminates in the
knurled region of the intermediate pipe. The knurled section on the intermediate pipe must be at the coupler lip.
6. Tighten the exhaust coupler nuts.
^
Tighten to 48 Nm (35 lb-ft).
^
Alternately tighten, in 10 Nm (89 lb-in) increments.