Mustang V6-4.0L (2008)
6. NOTE: Do not fully tighten the cam bolts until the alignment has been corrected.
Position the wheel spindle and install a cam adjusting nut and bolt in the bottom location, using the opposite orientation noted in Step 4. Then
install a new bolt and flag nut in the top location.
^
Tighten the upper bolt and cam nut until snug.
7. Position the brake line bracket and install the bolt, connect the wheel speed sensor wire to the bracket.
^
Tighten to 20 Nm (15 lb-ft).
8. Position the wheel speed sensor and install the bolt.
^
Tighten to 15 Nm (11 lb-ft).
9. Using alignment equipment and the manufacturer's instructions, measure the front camber.
10. Using the cam bolt, adjust the front camber until it is within specifications.
^
Tighten the strut-to-wheel spindle cam nut to 200 Nm (148 lb-ft).
^
Tighten the strut-to-wheel spindle upper bolt to 200 Nm (148 lb-ft).
11. Recheck the front camber settings, adjust as necessary.