Mustang V6-4.0L (2008)
7. Remove the brake caliper bleeder screw cap and place a box-end wrench on the bleeder screw. Attach a rubber drain hose to the bleeder screw and
submerge the free end of the hose in a container partially filled with clean, specified brake fluid.
8. Loosen the brake caliper bleeder screw.
9. Using the special tool, fully retract the brake caliper piston and tighten the bleeder screw to 10 Nm (89 lb-in).
10. Repeat Steps 4 through 9 until clear, bubble free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
^
Install the bleeder screw cap.
11. Remove the 2 brake caliper bolts and the shop towel.
12. Install the outer brake pad.
13. Position the brake caliper and install the 2 brake caliper bolts.
^
Tighten to 33 Nm (24 lb-ft).
