Mustang V6-4.0L (2008)
-
Fuel injection equipment is manufactured to very precise tolerances and fine clearances. It is essential that absolute cleanliness is observed when
working with these components or component damage can occur. Always install blanking plugs to any open orifices or tubes.
-
Do not use any tools. The use of tools may cause a deformity in the clip components which may cause fuel leaks.
1. If servicing a liquid fuel tube quick connect coupling, release the fuel system pressure.
2. Depress the legs of the retainer clip and position the clip in an outward position.
3. Disconnect the quick connect coupling from the tube.
Connect - Type IV
1. NOTE: Apply clean engine oil to the end of the tube and quick connect coupling O-ring seals.
Install the quick connect coupling onto the tube until fully seated.
2. NOTE: Make sure the retainer clip is fully seated and locked onto the tube by pulling on the quick connect coupling.
Press the retainer clip into the quick connect coupling body until flush and the legs are locked in place.
