Mustang V6-4.0L (2008)
1. Depower the SRS.
2. Lower the glove compartment door.
3. Disconnect the passenger air bag module electrical connector.
4. Remove the 2 air bag module bolts.
-
To install, tighten to 11 Nm (8 lb-ft).
5. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors. Damage to the passenger air
bag module may occur.
Through the glove box opening, release the deployment door clips (6 upper, 6 lower and 2 on each side) from the instrument panel and then
remove the passenger air bag module out of the instrument panel.
6. NOTE: During air bag module installation, make sure all the deployment door clips are fully seated into the instrument panel.
To install, reverse the removal procedure.
7. Repower the SRS.
