Mustang V6-4.0L (2008)
Removal
CAUTION: The steering gear bellows boots and clamps are designed to provide an airtight seal and protect the internal components of the
steering gear. If the seal is not airtight the vacuum generated during turning will draw water and foreign material into the gear causing
damage. Zip ties do not produce an airtight seal and must not be used.
CAUTION: The inner tie-rod ball joint grease is not compatible with water. Water trapped in the grease may damage the joint.
CAUTION: If present, the orientation of the vent tube must be noted so the boots and vent tubes may be installed in the correct location.
Incorrect venting may cause damage to internal components.
1. Remove the wheel and tire.
2. Loosen the tie-rod end jam nut.
3. Remove and discard the tie-rod end nut.
4. Using the special tool, disconnect the tie-rod end from the wheel knuckle.
