Mustang V6-4.0L (2008)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder
Material
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted or plastic surfaces. If the brake fluid is spilled onto a painted or plastic surface, wash
immediately with cold water.
1. Remove the brake pedal and bracket assembly.
2. Remove the retaining clip from the clutch pedal pin.
3. Remove the 2 clutch master cylinder bolts, then disconnect the clutch master cylinder from the clutch pedal.
^
To install, tighten to 10 Nm (89 lb-in).
4. Remove the reservoir hose from the clutch master cylinder.
5. To install, reverse the removal procedure.
^
Install new hose clamps on the reservoir hose.
^
Bleed the clutch hydraulic system.