Mustang V6-4.0L (2008)
Flywheel: Service and Repair
Flywheel
Lower End Components - Exploded View, Flexplate, Flywheel and Crankshaft Rear Seal
Removal
1. Remove the clutch.
2. Remove the 8 bolts and the flywheel.
Installation
1. NOTE: Special bolts are used for flywheel installation. Do not use standard bolts.
Position the flywheel. Install the 8 bolts and tighten in the sequence shown in 3 stages.
^
Stage 1: Tighten to 13 Nm (10 lb-ft).
^
Stage 2: Tighten to 50 Nm (37 lb-ft).
^
Stage 3: Tighten an additional 90 degrees.