Mustang V6-4.0L (2008)
-
The windshield glass must be positioned within 10 minutes of applying the urethane adhesive.
-
Use either a high-ratio, electric or battery-operated caulk gun that applies the urethane adhesive with less effort and a continuous bead.
Apply a bead of urethane adhesive to the pinch weld. Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead,
starting at the bottom of the windshield glass near the center.
10. CAUTION: Before positioning the windshield glass, open vehicle windows to prevent the air pressure of closing doors from affecting the
adhesive bond.
Using the alignment marks made previously, position the windshield glass on the pinch weld.
11. WARNING: Do not drive vehicle until the urethane seal has cured. Follow urethane manufacturer's curing directions. Inadequate or
incorrect curing of the urethane seal will adversely affect glass retention. Failure to follow these instructions may result in serious injury
to vehicle occupant(s).
NOTE: The urethane adhesive must cure for a minimum of one hour before testing for air or water leaks.
After the urethane has cured, check the windshield glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive
as necessary.
12. Install the interior rear view mirror.
13. Install the cowl vent screen.
Convertible
14. Install the header trim panel and the LH and RH A-pillar trim panels.
Coupe
15. Position the front portion of the headliner.
16. Install the LH and RH sun visors.
17. Install the overhead console.
18. Install the LH and RH A-pillar trim panels.
All vehicles
19. Install and adjust the wiper blade and pivot arms as necessary.
