Mustang V6-4.0L VIN N (2006)
Disconnect the electrical connector and remove the stop lamp switch.
4. NOTE: Do not apply the brake pedal during the removal or installation of the speed deactivation switch.
Disconnect the electrical connector and remove the speed deactivation switch.
5. Remove the redundant self-locking pin cover, self-locking pin and the booster rod pin.
6. Remove the 4 brake booster nuts.
^
To install, tighten to 25 Nm (18 ft. lbs.).
7. Remove the brake booster assembly from the vehicle.
8. To install, reverse the removal procedure.