Mustang V6-4.0L VIN N (2006)
-
To install, tighten to 39 Nm (29 lb-ft).
4. Remove the 2 bolts, the EGR system module and the gasket. Discard the gasket.
-
To install, tighten to 25 Nm (18 lb-ft).
5. CAUTION: Do not use metal scrapers, wire brushes, power abrasive disc or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of the old gasket.
NOTE: The EGR system module sealing surfaces are soft metals.
Carefully clean the EGR system module sealing surfaces.
6. To install, reverse the removal procedure.
-
Install a new gasket with the raised circle facing the throttle body adapter.