Mustang V6-4.0L VIN N (2006)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Front
Wheel Speed Sensor - Front
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Disconnect the wheel speed sensor electrical connector.
4. Disconnect the 3 wheel speed sensor harness pin-type retainers.
5. Disconnect the 2 wheel speed sensor grommet retainers from the brake hose clips.
6. Remove the wheel speed sensor bolt.
^
To install, tighten to 15 Nm (11 ft. lbs.).
7. Remove the wheel speed sensor and harness assembly.
8. To install, reverse the removal procedure.