Mustang V6-4.0L VIN N (2006)
Power Window Control Module: All Technical Service Bulletins
Body - Power Window 'Bounce-Back' Diagnostics
TSB 08-21-7
10/27/08
POWER WINDOW FEATURE - BOUNCE BACK DIAGNOSTICS
FORD:
2005-2009 Mustang
This article supersedes TSB 06-22-18 to update the vehicle model years and Service Procedure.
ISSUE
Some 2005-2009 Mustangs may exhibit issues with the power window One-Touch Up, Bounce Back and Short Drop features.
ACTION
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
NOTE
VERIFY PROPER DOOR GLASS/QUARTER GLASS ALIGNMENT BEFORE PERFORMING THIS PROCEDURE. REFER TO UPDATED
ONLINE WORKSHOP MANUAL (WSM), SECTION 501-11 FOR ALIGNMENT PROCEDURES.
NOTE
CHECK TO MAKE SURE THE DOOR SEAL AND/OR MIRROR SEAL ARE NOT ROLLED OVER OR BINDING. CHECK FOR
OBSTRUCTIONS IN GLASS SEALING AREA. CHECK TO MAKE SURE THAT REGULATOR FASTENERS ARE PROPERLY TORQUED.
Convertible Exhibiting Bounce Back:
Misaligned door glass will bounce back during operation if it contacts the inboard side of the upper convertible seal retainer. Concern may be duplicated
with top up and rear quarter windows down. Door glass must be aligned to both the convertible top and rear quarter glass division bar. Refer to updated
online WSM, Section 501-11 for alignment procedures before proceeding.
Coupe or Convertible Exhibiting Power Window Feature Issues:
Perform window motor glass de-initialization procedure, followed by re-initialization procedure, per online WSM, Section 501-11.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
082107A
2005-2009 Mustang:
0.2 Hr.
De-initialize, Then Initialize
The Power Window
Motor(s) Following The
Service Procedure
DEALER CODING
CONDITION
BASIC PART NO.
CODE
6323394
42
Disclaimer