Mustang V8-302 5.0L COBRA (1995)
Throttle Position Sensor: Service and Repair
Throttle Position Sensor
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect Throttle Position (TP) sensor from fuel charging wiring.
3. Remove two TP sensor retaining screws.
4. Remove TP sensor.
INSTALLATION
1. To install TP sensor, reverse removal procedure.
2. Tighten retaining screws to 2.8-3.8 Nm (25-34 in lb).
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control
module relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the adaptive strategy.