Mustang V8-302 5.0L COBRA (1995)
Constant Control Relay Module (CCRM): Service and Repair
REMOVAL and INSTALLATION
1. Remove radiator upper sight shield.
2. Disconnect headlamp dash panel function wire from constant control relay module.
3. Remove radiator coolant recovery reservoir retainer bolt.
4. Remove constant control relay module bracket retainers and bracketfrom radiator support.
5. Remove constant control relay module retaining screws and remove engine control sensor wiring from bracket.
6. To install reverse removal procedure. Tighten constant control relay module retaining screws securely. Tighten constant control relay module
bracket retainer bolts to 7.6-10.4 Nm (67-92 lb in). Tighten radiator coolant recovery reservoir retainer bolt to 4.5-6.3 Nm (40-56 lb in).