Mustang V8-302 5.0L COBRA (1995)
5. Carefully slit and cut away just enough cloth and sound insulation material to allow the tether anchor to be inserted through the slot in the rigid
panel material as shown in the following illustration.
6. Install the tether anchor using the parts supplied in the tether anchorage kit.
WARNING: THE TETHER ANCHOR BRACKET MUST BE BOLTED DIRECTLY TO THE SHEET METAL.
WARNING: TIGHTEN THE ANCHOR TO 22-34 Nm (16-25 LB-FT). OTHERWISE, THE SAFETY SEAT MAY NOT BE PROPERLY
SECURED AND THE CHILD MAY BE INJURED IN A SUDDEN STOP OR COLLISION.
WARNING: THE THREADED HOLE IN THE TETHER ANCHOR OR RETAINING NUT HAS AN 8 MM METRIC THREAD. A
WRENCH WILL BE NEEDED TO TIGHTEN THE 8MM BOLT TO THE REQUIRED TORQUE. SOME CHILD RESTRAINTS
COME WITH A NON-METRIC BOLT WITH A DIFFERENT THREAD. DO NOT USE A NON-METRIC BOLT AS IT MAY BE
IMPOSSIBLE TO SCREW IT ALL THE WAY INTO THE HOLE, RESULTING IN INADEQUATE RETENTION OF THE CHILD
RESTRAINT. USE ONLY THE METRIC ANCHOR BOLT SUPPLIED IN THIS KIT. IF YOU NEED A REPLACEMENT METRIC
BOLT OR RETAINING NUT, OR ASSISTANCE, ANY FORD DEALER WILL BE HAPPY TO ASSIST YOU.