Mustang V8-302 5.0L COBRA (1995)
Removal and Installation
1. Remove rear seat cushion and rear seat back.
2. Remove rear quarter trim panel.
3. Remove retractor anchor bolt.
4. Remove safety belt anchor-to-front floorpan bolt.
5. Remove rear seat shoulder belt retractor cover. Retain for installation on replacement rear safety belt retractor assembly.
6. To install, reverse Removal procedure. Make sure the safety belt webbing is not twisted. If it is, remove the twist. Tighten all safety belt retractor
and tongue retaining bolts to 30-40 N.m (23-29 lb-ft). Check restraint system for proper operation.
Outboard, Retractor and Tongue, Convertible
Special Service Tools Desired
Seat Belt Bolt Bit (#50 Torx) .......................................................................................................................................................................... T77L-2100-A