Mustang V8-302 5.0L COBRA (1995)
Fig. 8 Valve Cover Installation
16. Insert valve cover over dowel pins. Ensure outlet fitting hole in valve cover is aligned with square mounting lug on housing.
17. Place assembly in C-clamp and compress valve cover into pump housing until snap ring groove on housing is exposed.
18. Install valve cover snap ring in pump housing. Ensure snap ring ends are near access hole in pump housing.
19. Remove pump assembly from C-clamp.
20. Lubricate O-ring seal with power steering fluid, then place seal on pump housing.
21. Install reservoir on pump housing.
22. Install flow control valve and spring into valve cover.
23. Lubricate O-ring seals with power steering fluid, then place seals on outlet fitting.
24. Install outlet fitting on valve cover. Tighten outlet fitting to specifications. Use care not to cock flow control valve when installing. Do not force
valve forward otherwise damage to housing may result.