Mustang V8-302 5.0L HO (1987)
11.
Apply three medium wet coats (2.0 mils total) of enamel or urethane single stage following the manufacturer's label recommendations and flash
times.
^
BASF # HS SOLO
^
PPG # DELTRON
^
S-W # ULTRA ONE STAGE/TURBO
^
DuPont # CHROMAONE
^
Sikkens # AUTOCRYL
^
Spies Hecker # Series # 257
^
ICI P420 P421
NOTE:
FORD MOTOR COMPANY WILL NOT PAY FOR CLEARCOAT ON VEHICLES THAT DID NOT HAVE IT AVAILABLE IN PRODUCTION.
12.
After the paint is dry, demask the entire vehicle and clean up any areas which have overspray.
13.
Install all trim (mouldings, name plates, striping, etc.) on the vehicle which were removed prior to repainting. Use applicable labor operations.
14.
Clean the interior and exterior of the vehicle thoroughly, including air ducts.
WARNING:
TO SAFEGUARD OUR ENVIRONMENT, PLEASE USE PROPER DISPOSAL TECHNIQUES FOR ANY VOLATILE ORGANIC COMPOUNDS
(VOC) OR EXCESS MATERIALS.
LABOR TIME AND MATERIAL ALLOWANCE CHART
