Mustang V8-4.6L (2009)
Arm/Disarm Switch: Service and Repair
Door Disarm Switch
Removal
1. Remove the LH front door trim panel.
2. Position the watershield aside.
3. Disconnect the door disarm switch electrical connector.
4. Separate the door disarm switch wiring harness retainer from the post on the LH door latch.
5. Remove the E-clip.
6. Remove the lock cylinder actuator pawl.
7. Remove the door disarm switch.
Installation
1. Before installing the door disarm switch, pack both the switch and the door lock cylinder with dielectric grease (or equivalent) in the positions
shown.
