Mustang V8-4.6L (2009)
![background image](/ford/mustang/v8-4.6l/Page-1159001.png)
Accelerator Pedal: Service and Repair
Accelerator Pedal
Removal and Installation
1. Disconnect the accelerator pedal sensor electrical connector.
-
During installation, make sure that the red lock tab on the electrical connector is fully engaged to make sure of a complete connection.
2. Remove the 3 nuts and the accelerator pedal and sensor.
-
To install, tighten to 9 Nm (80 lb-in).
3. To install, reverse the removal procedure.