Mustang V8-4.6L (2009)
Communications Control Module: Removal and Replacement
Audio Control Module (ACM)
Removal and Installation
NOTE: It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, refer to Audio Unit Part
Number Retrieval See: Procedures/Audio Unit Part Number Retrieval.
NOTE: If installing a new navigation ACM, remove the navigation DVD, if possible, before sending the ACM to an authorized audio system repair
facility.
1. NOTE: Module configuration is only required if a new ACM is being installed.
Upload the ACM configuration information to the scan tool. For additional information, refer to Information Bus, to carry out Programmable
Module Installation (PMI). See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming
and Relearning
2. Remove the instrument panel center finish panel.
3. Remove the 4 screws and the ACM.
-
Disconnect the electrical connectors and the antenna lead-in cable.
4. To install, reverse the removal procedure.
-
Download the configuration information to the ACM. For additional information, refer to Information Bus, to carry out PMI. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning