Mustang V8-4.6L (2009)
Remove the instrument cluster finish panel.
2. Remove the floor console finish panel.
3. Remove the LH A-pillar lower trim panel.
4. Remove the left center stack wing.
5. Remove the 2 screws and the steering column opening cover.
-
Disconnect the headlamp and courtesy light switch electrical connectors.
6. Remove the 4 bolts and the steering column opening cover reinforcement.
-
To install, tighten to 9 Nm (80 lb-in).
7. Remove the upper steering column shroud by carefully pressing the sides inward.
8. Remove the 3 lower steering column shroud screws and the shroud.
Turn signal/headlamp switch
9. Disconnect the turn signal/headlamp switch electrical connector.
10. Remove the 2 screws and the turn signal/headlamp switch.
Windshield wiper/washer switch
11. Disconnect the windshield wiper/washer switch electrical connector.
12. Remove the 2 screws and the windshield wiper/washer switch.
Turn signal/headlamp switch and windshield wiper/washer switch
13. To install, reverse the removal procedure.