Mustang V8-4.6L (2009)
Installation
NOTICE: Do not use air tools to install the wheel stud. The serrations in the hub flange may be stripped.
1. Position the wheel stud in the axle flange, making sure that the serrations are aligned with those made by the original wheel stud.
2. Position washers and a reversed wheel nut on the wheel stud and tighten the wheel nut until the stud seats on the back of the axle flange.
3. Remove the wheel nut and washers.
-
Discard the nut.
4. Install the rear brake disc.
5. Position the brake caliper and anchor plate assembly and install the bolts.
-
Tighten to 103 Nm (76 lb-ft).