Mustang V8-4.6L DOHC (1996)
6.
Using an appropriate depth gage, carefully measure from the case mounting face of the extension housing to the face of the plain washer, which
should be stuck in the modeling clay. Take three (3) readings and calculate the average. This is the measure of reverse engagement.
7.
Using the following criteria, select the correct 5th/reverse fork. This fork should replace the current fork in the transmission.
a.
If the measurement is less than 68.1158 mm (2.682 inches), use the "long" fork (F8ZZ-7230-EA).
b.
If the measurement is greater than 69.233 mm (2.726 inches), use the "short" fork (F8ZZ-7230-DE).
c.
If the measurement falls between the above values, then install the "nominal" fork (F6ZZ-7230-C).
8.
Remove and replace the current fork with the new fork, per the Workshop Manual procedure.
9.
Clean the joint surfaces of the castings (main and extension housing) and shifter.
10.
Re-assemble per Workshop Manual.
11.
Verify repair
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION
DESCRIPTION
TIME
012305A
Replace The Reverse Shift
3.6 Hrs.
Fork (Includes Time To
Remove, Disassemble,
Measure And Reinstall
Transmission)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
7230
42
OASIS CODES: 505000