Mustang V8-4.6L VIN H (2005)
2. Disconnect the mass air flow (MAF) sensor electrical connector.
3. Remove the air cleaner assembly bolt.
-
To install, tighten to8 Nm (71 lb-in).
4. NOTE: Make sure that the 2 rubber grommets are retained to the air cleaner assembly feet.
Remove the air cleaner assembly.
5. NOTE:
-
Make sure that the 2 air cleaner assembly feet rubber grommets are seated into the locating holes in the fender.
-
The air cleaner outlet pipe should be securely sealed to prevent unmetered air from entering the engine.
To install, reverse the removal procedure.