Mustang V8-5.4L SC (2008)
CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose may occur.
Remove the bolts and position the caliper and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
3. Remove the rear brake disc.
4. Using the special tool, remove and discard the wheel stud.
Installation
CAUTION: Do not use air tools to install the wheel stud. The serrations in the hub flange may be stripped.
1. Position the wheel stud in the axle flange, making sure that the serrations are aligned with those made by the original wheel stud.
2. Position washers and a reversed wheel nut on the wheel stud and tighten the wheel nut until the stud seats on the back of the axle flange.
3. Remove the wheel nut and washers.
^
Discard the nut.
4. Install the rear brake disc.
5. Position the brake caliper and anchor plate assembly and install the bolts.
^
Tighten to 103 Nm (76 lb-ft).
