Mustang V8-5.4L SC VIN S (2007)
Removal and Installation
WARNING: Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the
brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Disconnect the battery ground cable.
2. Remove the air cleaner assembly.
3. Disconnect the anti-lock brake system (ABS) module electrical connector.
4. NOTE: Brake tubes must be installed in the same location as removed.
Loosen the 6 brake tube-to-hydraulic control unit (HCU) fittings, disconnect and position the brake tubes aside.
-
To install, tighten to 17 Nm (13 ft. lbs.).
5. Remove the 3 HCU bracket-to-frame bolts.
-
To install, tighten to 25 Nm (18 ft. lbs.).
6. Remove the HCU assembly.
7. If necessary, remove the HCU bracket bolt and bracket.
-
To install, tighten to 11 Nm (8 ft. lbs.).
8. To install, reverse the removal procedure.
-
Bleed the brake system.