Mustang V8-5.4L SC VIN S (2007)
7. NOTE: A similar RCM and connectors are shown.
Disconnect the large restraint control module (RCM) electrical connector.
1
Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
2
Pull out and disconnect the large RCM electrical connector.
8. Disconnect the small RCM electrical connector.
9. Remove the 3 nuts and the RCM.
Installation
1. WARNING: The tightening torque of the air bag restraints control module (RCM) retaining nuts is critical for correct system operation.
Position the RCM and install the nuts.
-
To install, tighten to 12 Nm (9 lb-ft).
2. Connect the small RCM electrical connector.
3. Make sure the large RCM connector position assurance lever is in the full RELEASE position before attempting to connect the connector.