Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Alarm System Transponder: Service and Repair
Removal and Installation
REMOVAL
1. Remove ignition switch lock cylinder from steering column housing.
2. Remove screw retaining passive anti-theft transceiver module to steering column lock cylinder housing.
NOTE: Only apply pressure or leverage below the key cylinder lower rib.
3. Locate rib on steering column lock cylinder housing, using a small screwdriver gently pry passive anti-theft transceiver module over the rib.
4. Disconnect passive anti-theft transceiver module from steering column locators and wiring harness connector and remove transceiver from vehicle.
INSTALLATION
1. Locate post on passive anti-theft transceiver module, and align to bottom slot of key cylinder barrel on steering column lock cylinder housing.
2. Apply even pressure to top surface of passive anti-theft transceiver module and snap passive anti-theft transceiver module over the casting rib on
steering column lock cylinder housing.
3. Position the rib on transceiver case within the two walls of the cavity on the steering column lock cylinder housing, to prevent movement.
4. Install passive anti-theft transceiver module retaining screw to steering column lock cylinder housing. Tighten to 1.8-2.6 N.m (16-23 lb-in).
5. Connect passive anti-theft transceiver module to steering column bracket, and connect harness connector.
