Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
9. Remove speed control cable slug from speed control servo pulley. Gently push actuator cable slug past retaining spring with a small screwdriver.
INSTALLATION
1. Install speed control servo to speed control servo bracket. Tighten screws to 6-7 N.m 53-62 (lb-in).
2. Make sure that the rubber seal is snug against speed control actuator cap.
3. Install speed control actuator cable slug into speed control pulley slot. Make sure that the slug is fully installed past the retaining spring.
NOTE: Incorrect wrapping of speed control actuator cable core around speed control servo pulley may cause a high idle condition. Make sure
that the throttle lever is at the idle position after speed control cable installation and adjustment.
4. Pull on throttle attachment end of speed control actuator cable and draw the speed control actuator cap onto the speed control servo pulley.
5. Install speed control actuator cap by inserting locking tabs into speed control servo slots. Rotate cap clockwise until cap locking arm engages slot
on speed control servo.
NOTE: Proper assembly of speed control servo can be verified by a white band on the speed control actuator cable being visible.
