Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Pressure Feedback Exhaust Sensor: Service and Repair
REMOVAL
1. Disconnect fuel charging wiring connector from pressure feedback exhaust sensor.
2. Disconnect hoses from pressure feedback exhaust sensor.
3. Remove retaining nuts and pressure feedback exhaust sensor from mounting bracket.
4. If necessary, remove the mounting bracket.
NOTE: Remove the EGR tube heat shield.
INSTALLATION
1. Follow removal procedure in reverse order.
2. If removed, tighten retainers for the mounting bracket and EGR tube heat shield to 8-12 Nm (71-106 lb in). Tighten EGR retaining nuts to 5-7 Nm
(45-61 lb in).