Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Alarm Module: Service and Repair
Key Initialization
Key Initialization
The system provides a key initialization procedure in the event all keys programmed into the system have been lost, or only one key was lost and the
customer wants to make sure the lost key will no longer start his vehicle.
The vehicle protection system also allows for the reprogramming of the system if the ignition lock assembly requires replacement. This mode requires
only one encoded key be programmed before the passive anti-theft system module will send the vehicle enable message to the Powertrain Control
Module (PCM).
To erase all keys in memory and store an unprogrammed key in memory, See: Spare Key Programming
-
If a programmed encoded ignition key is available:
(1) Place key in ignition switch and turn to RUN position.
(2) Enter NGS: PATS, ACTIVE COMMAND modes.
(3) Select ignition key code ERASE ON (within 5 seconds, all key codes stored will be erased).
(4) Turn ignition switch to OFF and then back to RUN position to program the first key into memory.
(5) Follow spare key programming procedure as described for programming in any additional keys required.
-
If no programmed keys are available follow the procedure outlined above; however, instead of taking 5 seconds to complete key erasing, it will
take a minimum of 8 minutes.
An alternate programming method is possible and is intended to keep a customer from being stranded, and who has no access to a service facility
equipped with diagnostic tools. This interactive procedure takes approximately 45 minutes to maintain the high level of theft protection provided by
the system. When initializing the system using this procedure, it must be followed precisely or the system will abort and the procedure will need to be
started over.
The alternate programming method operates as follows:
-
Insert an unprogrammed encoded key into the ignition lock and turn ignition switch to RUN. The THEFT Indicator will begin flashing.
-
Follow this procedure three times: After 15 minutes of flashing, the THEFT indicator will extinguish. Within five minutes after the THEFT
indicator has gone out, turn the ignition switch once to OFF for a second, then back to RUN. The THEFT indicator will resume flashing for
another 15 minutes.
-
After the third time (at 45 minutes from start), the control module will erase all stored keys and memorize the unprogrammed key as valid. This
key will now start the vehicle. Additional keys can be programmed using the Spare Key Programming procedure.
