Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Seat Belt Buckle: Service and Repair
Removal and Installation
REMOVAL
1. Position front seat forward to reach front safety belt buckle end.
2. Remove front safety belt buckle end anchor bolt and front safety belt buckle end. On LH side, disconnect safety belt buckle switch connector.
INSTALLATION
1. On LH side, connect safety belt buckle switch connector. Install front safety belt buckle end and front safety belt buckle end anchor bolt. Tighten
to 34-46 Nm (25-33 lb ft).
2. Check the restraint system for proper operation and perform Functional Test Procedure.