Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
3. Tighten fittings at pump to 34-46 Nm (25-33 ft. lbs.). Tighten fitting at gear to 27-34 Nm (20-25 ft. lbs.). Tighten hose clamps to 1-3 Nm (9-26
inch lbs.).
4. Install screw at power steering hose bracket.
5. Install anti-rattle clip.
6. Install plastic strap retaining power steering pressure hose and power steering return hose to transfer tube on power rack and pinion steering gear.
7. Install wiring harness guide.
8. Position constant control relay module to top of fan shroud and connect constant control relay module harness to headlamp harness.
9. Install fan shroud.
10. Connect electrical connector to engine cooling fan motor.
11. Install engine air cleaner.
12. Connect battery ground cable.
13. Refer to System Flushing.