Mustang Cobra V8-281 4.6L DOHC VIN V MFI (1997)
Output Shaft: Service and Repair
Disassembly
NOTE: The following procedure should be performed only when necessary. After carefully inspecting each subassembly, disassemble only those
requiring component replacement or further inspection.
DISASSEMBLY
1. Remove main gearshift rail and gearshift forks from output shaft.
2. Remove third-fourth synchronizer hub retaining ring from front of output shaft.
3. Install Bearing Pulling Attachment D79L-4621-A or equivalent between second speed gear and third speed gear with flat side of puller toward
third speed gear as shown.
CAUTION: Only hand-tighten bearing puller to prevent damage to gear.
4. Using a press and Bearing Pulling Attachment D79L-4621-A or equivalent, remove third/fourth synchronizer, third speed synchronizer blocking
ring, and third gear as an assembly.