Mustang Cobra V8-4.6L DOHC VIN V (2000)
Brake Bleeding: Service and Repair
Four Wheel ABS Hydraulic Control Unit (HCU)
Note: This procedure only needs to be performed if the 4-wheel anti-lock brake (4WABS) hydraulic control unit (HCU) has been installed new or if
the HCU lines have been opened.
1. Clean all dirt from and remove the brake master cylinder filler cap, and fill the brake master cylinder reservoir with the specified brake fluid.
2. Connect a clear waste line to the RH rear bleeder screw and the other end in a container partially filled with recommended brake fluid.
3. Loosen the RH rear bleeder screw until a stream of bake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the RH
rear bleeder screw.
^
Repeat until clear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
4. Tighten the RH rear bleeder screw, and disconnect the waste line.
