Mustang Cobra V8-4.6L DOHC VIN V (2000)
10. Seat the CV joint stub shaft in the differential side gear.
1. Slide the stub shaft into the differential housing until the shaft splines are past the differential seal.
2. Remove the special tool.
3. Align the stub shaft splines and the side gear splines, and slide the stub shaft into the gear until it seats.
^
When seated, the axle circlip will lock the stub shaft in the differential side gear. Check the circlip engagement by attempting to pull the
inboard CV joint out of the differential side gear. If the circlip has not seated, push the CV joint inward until the circlip is fully engaged in
the differential side gear.
11. CAUTION: Do not tighten the fastener at this time.
Connect the knuckle to the upper suspension arm and bushing.
1. Position the knuckle.
2. Install the new cam bolt and nut.
12. CAUTION: Do not tighten the fastener at this time.
Connect the knuckle to the lower suspension arm and bushing.
1. Position the knuckle.
2. Install the new bolt and nut.