ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Alarm System Transponder|Service and Repair > < Anti-Theft Passive|Page 7399
Page 2
background image

to an armed state and will trigger again if another intrusion occurs. However, the vehicle's starter circuit will remain disabled until the system is
disarmed.

The alarm system will be activated if any of the following actions occur after the system has been armed:

^

opening either front door without first unlocking with door key.

^

removing luggage compartment door lock cylinder.

Disarming a Triggered System

NOTE:  Any of the following procedures will disarm a triggered system.

^

Unlock driver or passenger front door with the key.

^

Unlock driver front door by pressing UNLOCK button of keyless entry remote transmitter.

Panic Alarm Activation

The personal security alarm can only be operated from the keyless entry remote transmitter as follows:

^

Pressing the button marked PANIC on the keyless entry remote transmitter will cause the horn to sound.

^

Also, the low beam headlamps and the parking lamps and rear lamp will flash.

^

NOTE:  The personal security feature is controlled by the electronic door lock control processor. It is completely independent of the anti-theft
alarm control module. The personal security feature can only be deactivated by pressing PANIC button again or turning the ignition switch to
RUN or ACC.

Alarm System Transponder|Service and Repair > < Anti-Theft Passive|Page 7399