Mustang GT V8-4.6L SOHC VIN X (1998)
REMOVAL
Special Tool
1. WARNING: DO NOT ALLOW AXLE SHAFT FLANGE TO CONTACT PRESS BED DURING REAR BRAKE ANTI-LOCK
SENSOR INDICATOR REMOVAL.
CAUTION: After removing a rear brake anti-lock sensor indicator, replace with a new rear brake anti-lock sensor indicator.
Remove axle shaft. Place axle shaft in press as shown and remove rear brake anti-lock sensor indicator. Discard rear brake anti-lock sensor
indicator.
INSTALLATION
1. Position Sensing Ring Replacer 206-041(T89P-20202-A) on press with pilot ring up.