Probe L4-121 2.0L DOHC VIN A MFI (1993)
Alignment: Service Precautions
DISARMING
1. Disconnect battery ground cable. Allow at least one minute for back-up power supply to deplete.
2. Remove four nut and washer assemblies retaining driver's air bag module to steering wheel.
3. Disconnect driver's air bag module connector.
4. Connect Rotunda Air Bag Simulator 105-00009, or equivalent, to vehicle air bag wiring harness at top steering column.
5. Connect battery ground cable.
ARMING
1. Disconnect battery ground cable. Allow one minute for back-up power supply to deplete.
2. Remove air bag simulator from harness on top of steering column.
3. Connect driver's air bag connector.
4. Position driver's air bag on steering wheel and secure with four nut and bolt assemblies.
5. Connect battery ground cable.
6. Place ignition switch in RUN position and note air bag warning lamp operation. Indicator lamp should illuminate for approximately six seconds,
then turn OFF.