Probe L4-133 2.2L SOHC (1990)
Figure 2
4.
Refer to the 1991 Probe Shop Manual, Section 04-00, pages 4 and 5 for tire wear inspection and rotation procedures. Tire rotation on GL and LX
can be rotated as noted in figure 2, however, the GT model with directional tires must be rotated front to rear and not crossed. Excessively worn
tires should be replaced.
5.
Road test vehicle again, following the procedures and warnings as stated in steps 2 and 3. If the drift condition is still seven (7) seconds or less
proceed to step 6.
6.
Refer to Section 04-00, pages 7-9 for a description of Caster, Camber, Toe-in, and adjustment procedures.
NOTE:
SET FRONT TOE-IN TO "O" EACH WHEEL AND REAR TOE-IN AT 1.5 MM EACH WHEEL.
Figure 3
