Probe V6-153 2.5L DOHC (1994)
ABS Wheel Speed Sensor: Service and Repair
Toothed Ring
Front
Wheel Sensor Removal
1.
Remove wheel and tire assembly.
2.
Remove halfshaft.
3.
Using a soft faced drift, tap sensor rotor from outboard CV joint.
4.
Reverse procedure to install.
Rear
REMOVAL
1. Remove the hub/wheel bearing.
2. Use Push-Puller set D80L-927-A, Bearing Pulling Attachment D84L-1123-A, King Pin Seal Installer T86T-3110-AH, and Protector D80L-625-A
to remove the wheel sensor rotor. Discard the old part.
INSTALLATION
CAUTION: Install the new sensor rotor with the chamfered edge toward the wheel hub.
1. Use Rear Sensor Ring Replacer T88P-20202-B and a hydraulic press to press in a new rear wheel sensor rotor.
2. Reinstall the hub/wheel bearing.