Probe V6-153 2.5L DOHC (1994)
a.
Measure the gap between the door drip edge moulding and the outside glass surface along the horizontal area of the top of the glass. See
Figures 10 and 11 - points A through B. The correct gap is 3.5-4.0 mm.
b.
Use your hands to adjust the drip edge moulding by applying pressure to bend the moulding to provide the required gap. Use caution to
bend the drip edge moulding evenly to avoid a wavy appearance.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 93-22-1
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage. Adjustments & Alignments Are Covered For 12 Months/12,000 Miles
OPERATION DESCRIPTION
TIME
940504AT
Check And Adjust Door And
0.4 Hr.
Striker Only - Both Doors
940504A
Check And Adjust Door And
0.3 Hr.
Striker Only - One Door
940504BT
Check And Adjust Glass
0.9 Hr.
Only - Both Doors
940504B
Check And Adjust Glass
0.5 Hr.
Only - One Door
940504CT
Check And Adjust Door And
1.1 Hr.
Door Glass - Both Doors
940504C
Check And Adjust Door And
0.6 Hr.
Door Glass - One Door
DEALER CODING
BASIC PART NO.
CONDITION CODE
7021778
36
OASIS CODES: 102000, 110000, 190000, 701000