Probe V6-182 3.0L (1990)
Determine the source of the water entry and repair as required. Install a new inertia switch and protective cover. Refer to the following procedure for
service details.
NOTE:
Review the 1990 Probe shop manual sections 24-35 on the fuel pump circuits and 41-54 pin 2F GN/BK wire from the passive restraint module to the
inertia switch. The 1990 Probe EVTM page 23-1, 24-2, 25-2, 25-3, and 45-1 should be consulted for wire color codes, locations and routing.
1.
Install a memory saver and disconnect the battery negative cable.
2.
Locate and access the inertia switch. See Figure 1.
3.
Check for water leaks in the area.
a. Identify the source of any water leaks.
b. Seal the area as required.
4.
Remove the inertia switch.
a. Remove the affected bolts.
b. Disconnect the electrical connector from the switch.
c. Remove the inertia switch from the mounting bracket.
5.
Install a new inertia switch on the mounting bracket.
