Front Wheel Alignment – Castor and Camber
| Derivative | Values In | Castor | Castor | Camber | Camber |
| | | Nominal | Tolerance Range | Nominal | Tolerance Range |
| All variants | Decimal degrees | 2.50° | 3.75° to 1.25° | -0.90° | 0.20° to -2.00° |
| All variants | Degrees and minutes | 2°30' | 3°45' to 1°15' | -0°54' | 0°12' to -2°00' |
Maximum variation - left to right-hand side - Castor 1.00° (1°00') Camber 1.25° (1°15')
Front Wheel Alignment – Toe Setting
| Values In | Allowable Tolerance | Setting Adjustment |
| mm | 0.5mm Toe in to -4.5 mm Toe out | -2.0mm Toe out ± 1.0mm |
| Degrees and minutes | 0°05' Toe in to -0°45' Toe out | -0°20' Toe out ± 0°10' |
| Decimal degrees | 0.08° Toe in to -0.76° Toe out | -0.33° Toe out ± 0.17° |
Rear Wheel Alignment - Camber
| Derivative | Values In | Camber | Camber |
| | | Nominal | Tolerance Range |
| All variants | Decimal degrees | a) | a) |
| All variants | Degrees and minutes | a) | a) |
Maximum variation - left to right-hand side - Castor 1.25° (1°15')
a) refer to Beam Axle Identification table.
Rear Wheel Alignment - Toe Setting
| Nominal | Tolerance Range |
| 0.46° Toe in | 0.79° to 0.13° Toe in |
| 3.0 mm Toe in | 5.0 mm to 1.0 mm Toe in |
Torque Specifications
| Description | Nm | lb-ft | lb-in |
| Tie-rod end locknut | 63 | 46 | - |
Beam Axle Identification
| Beam Axle Part Number | Tolerance Range | Setting or Nominal | Maximum Variance Left or Right |
| 98FB 5K952-DA | Decimal degrees | -0.50° to -2.00° | -1.00° | 1.25° |
| Degrees and minutes | -0°30' to -2°00' | -1°00' | 1°15' |
| 98FB 5K952-DB | Decimal degrees | -0.50° to -2.00° | -1.00° | 1.25° |
| Degrees and minutes | -0°30' to -2°00' | -1°00' | 1°15' |
| 98FB 5K952-DD | Decimal degrees | -1.30° to -2.80° | -1.80° | 1.25° |
| Degrees and minutes | -1°18' to -2°48' | -1°48' | 1°15' |
| V97FB 5K952-AB | Decimal degrees | -0.50° to -2.00° | -1.00° | 1.25° |
| Degrees and minutes | -0°30' to -2°00' | -1°00' | 1°15' |
