ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Front Seat Cushion - Vehicles Built From: 01-1999 > < Diagnosis and Testing|Seats

Puma 1998 (06.1997-12.2001)

Seating - Front Seat Puma 1998 (06/1997-12/2001)
Removal and Installation

Removal

WARNING:
WARNING:Wait at least 15 minutes after disconnecting the battery before disconnecting the air bag control module electrical connector. For all other supplementary restraints system electrical connectors; wait two minutes. Failure to follow these procedures could increase the possibility of accidently deploying the air bag(s) and pyrotechnic pre-tensioners.
  1. Disconnect the battery ground cable.

  1. Remove the runner trim.
    1. Unclip the trim.
    1. Remove the trim.

  1. Detach the seat side trim cover.

  1. Remove the seat side trim cover.
    1. Detach the pyrotechnic pretensioner and power height adjuster wiring harness (if equipped).
    1. Remove the trim.

  1. Disconnect the electrical connector(s).

  1. Remove the seat track front retaining bolts.

  1. Remove the seat track rear retaining bolts.
  1. Remove the seat.

Installation
  1. To install, reverse the removal procedure.

Front Seat Cushion - Vehicles Built From: 01-1999 > < Diagnosis and Testing|Seats