General Procedures Adjustment | -
CAUTION:Do not touch the adhesive surface as re-bonding will be impaired. Detach the door panel watershield. - Using a plastic knife (disposable cutlery), cut through the Butyl strip to enable the watershield to be peeled back.
| | -
Connect the window operating switch electrical connector. | | -
Loosen the window glass clamp retaining screws. - Align the retaining screws with the access hole.
| | -
Make sure the glass is inside the door frame outer seal. | | -
Lower the glass to the bottom. | | -
Standing inside the door, apply rearward hand pressure on the outside of the window glass, at the same time raising the glass to its fully closed position. | | -
Tighten the window glass clamp retaining screws. | | -
Attach the door panel watershield. | | |